Classiformas
It is the new line of interior moldings that FANOSA is launching to the market; the five models to choose from are easy to install, just affix them and paint them. The designs are taken from classic styles.
This new line of moldings has the special characteristic of being molded to a greater density in the expanded polystyrene (EPS), which leads to a better finish and greater rigidity.
 |
 |
Where can I get these products?
They can be found in hardware stores, distribution centers, and at our FANOSA plants.
Do they need any special care?
It is recommended to install them at a height greater than 1.50 so they are not exposed to bumps or hits.
Are these products more expensive than traditional materials?
It is actually the other way around, they are cheaper, and they are also easy to install and easy to handle because of their lightweight.
Can the Classiformas be installed by oneself?
Yes, they can because their installation is very simple. It can be done with the help of the installation manual and following the recommended steps. If you prefer, they can also be installed by a plasterer, molding installer, o any other person with the proper knowledge.
What is the best way to affix the moldings?
Any adhesive can be used; the affixing instructions can be obtained through technical assistance at our Fanosa plants.
Can a design be custom-produced? .
In this case, no other designs can be produced because they are pieces molded with pre-established designs.
What material can be used to fill the joints between two moldings?
It is recommended to use the same adhesive in the joints and as a covering for the bare molding.
What are the main advantages Classiformas offer?
They are lightweight, come in five different designs that offer versatility when designing your space, offers the looks of plaster casts, they are ready to be painted so you can create your own combinations on finishes and colors, it is of a high density so they are more resistant to bumps, appearance and finish, easy to install, just affix and paint, with our moldings you have the opportunity of adding value to your space.
Do Classiformas need to be covered or are they ready to be painted?
Since they are of high density, they do not need any additional covering and are ready to be painted, they can even be left in their original form.
